Connecting To A Pressure Pot Or Two Quart System; Using The Top Feed Gun; Converting The Gun To A Regulator Gun; Converting The Gun From Non-Bleeder To Bleeder - CAPspray Maxum II HVLP Notice D'utilisation

Connecting to a Pressure Pot or
Two Quart System
1. Connect the compressor air hose to the pressure pot inlet.
Pressure Pot Inlet
Compressor Air Hose
Compressor
2. Thread one end of the material hose onto the pressure
pot outlet and tighten.
3. Thread the other end of the material hose onto the spray
gun fluid inlet and tighten.
Pressure Pot Outlet

Using the Top Feed Gun

The top feed HVLP spray gun is
designed for use in special
applications such as spraying in
confined areas. The position of the
cup gives the top feed gun the ability
to spray downward and overhead.
When spraying with the top feed gun,
remember the following tips for the
best results. Keep the cup level
when spraying at an angle. The
special fluid inlet fitting on the gun
allows the cup to rotate to remain
level when the gun is at an angle.
Keep the cup pressurized at all times
when spraying. Attempting to gravity
feed the material will slow or stop the
flow of material at the nozzle.
Converting the Gun to a
Regulator Gun
Your HVLP spray gun can be converted to connect directly to
existing high pressure air systems with the addition of a
regulator assembly.
1. Remove the air inlet fitting at the bottom of the gun handle
using a wrench.
English
Material Hose
Spray Gun
Fluid Inlet
Material
Hose
2. Thread the fitting on the regulator assembly into the air
inlet at the bottom of the gun handle and tighten.
Air Inlet
Fitting
3. Attach the air hose from the existing high pressure air
system to the regulator assembly.
4. Set the pressure gauge on the regulator assembly to the
appropriate setting for the coating being sprayed.
NOTE: Standard air caps require an air flow of 15 –
25 SCFM. Low air flow air caps are available
for the regulator gun to use with smaller air
compressors. See "Optional Accessories"
for the part numbers.
Converting the gun from Non-
Bleeder to Bleeder
Your HVLP spray gun can be converted from a non-bleeder to
a bleeder setup. Bleeder setup provides more atomizing
power for higher viscosity materials, such as latex and
enamels. Bleeder setup can make it easier to spray in
confined spaces, such as inside cabinets, because the air
hose is moved to the back of the gun.
To convert a spray gun to bleeder setup:
1. Remove the air flow adjustment knob from the rear of the
gun using a wrench.
2. Remove the air inlet fitting from the bottom of the gun
handle using a wrench.
3. Thread the air inlet fitting into the air flow adjustment knob
location at the rear of the gun. Secure the fitting in place.
Air Flow
Adjustment
Knob
4. Thread the air inlet plug (shipped loose with the gun
literature pack) into the air inlet at the bottom of the gun
handle. Secure the plug in place.
Air Inlet
Plug
8
Regulator
Assembly
Air Inlet
Fitting
© SprayTECH. All rights reserved.