Service; Introduction; Using An Hvlp Spray Gun; Preparing To Spray - CAPspray Maxum II HVLP Notice D'utilisation

Service

Should your HVLP spray gun need service during the warranty
period, return the unit and the proof of purchase to the
distributor where it was purchased. At our option, the unit will
be repaired or replaced. In a continued commitment to improve
quality, we reserve the right to make component or design
changes when necessary.

Introduction

These spray guns are designed for use in a High Volume/Low
Pressure (HVLP) painting system.
With an HVLP system, the highest quality professional finish
can be achieved with little preparation or setup time. HVLP
systems are not intended to replace airless systems. Instead,
they are meant to compliment airless by improving the final
finish on the substrate, minimizing waste, and reducing labor
time. In addition to enhancing profitability, HVLP systems are
compliant with the most stringent transfer efficiency
requirements.
The HVLP spray guns described in this manual include the
turbine cup gun, the turbine regulator gun, the turbine top feed
gun, the regulator cup gun, and the regulator top feed gun.
Please review all the information contained in this manual
before operating an HVLP system.
NOTE: The general operation and maintenance of each
style of HVLP spray gun are the same. For
illustration purposes, the turbine cup gun is
pictured. However, any information specific to
a style of gun is described where necessary. A
parts listing for each style of gun is included
near the back of this manual.
Air Flow
Adj. Knob
Material Flow
Adj. Knob
Packing Nut
Trigger
Check Valve
Air Inlet
© SprayTECH. All rights reserved.

Using an HVLP Spray Gun

Preparing to Spray

1. Release the cup locking lever and remove the cup.
2. Fill the cup with the desired painting material. Make sure
that the cup gasket is clean and in position.
3. Place the cup on the spray gun and tighten the cup
locking lever.
4. Attach the air supply hose to the air inlet fitting at the
bottom of the gun handle.
5. Turn on the air supply.

Selecting a Spray Pattern

The spray pattern is adjusted by turning the air cap into either
a vertical, horizontal, or diagonal position. To turn the air cap,
grasp the two front tabs and twist. Never trigger the gun while
adjusting the spray pattern.
Air Cap Tabs
Air Cap Ring
Air Cap
Fluid Inlet
Cup Locking
Lever
Cup
Assembly
Swivel Tube
Lever
3
Vertical Horizontal
Tip Position Pattern
Diagonal Round
Tip Position Pattern
Horizontal Vertical
Tip Position Pattern
English