Spray Pattern Size; Adjusting The Material And Air Flow; Spraying; Adjusting The Swivel Tube - CAPspray Maxum II HVLP Notice D'utilisation

Spray Pattern Size

To change the spray pattern size without changing the spray
pattern shape, turn the air cap ring.
Turning the ring clockwise will make the pattern bigger.
Turning the ring counterclockwise will make the pattern
smaller. As you reduce the spray pattern size, you will need to
move closer to the surface.

Adjusting the Material and Air Flow

Each individual job and material may require slight
adjustments in the material flow and air flow.
Turn the material flow adjustment knob clockwise for less fluid
and counterclockwise for more fluid.
Material Flow
Adjustment Knob
More
Fluid
Turn the air flow adjustment knob to adjust for more or less air.
Set the mark on the knob straight up for maximum airflow.
Remember to test the spray on a piece of scrap wood or
cardboard before using.
Maximum Airflow
MAX
Minimum
Airflow
English
Smaller Bigger
Pattern Pattern
Air Cap Ring
Less
Fluid
Air Flow
Adjustment Knob

Spraying

Hold the spray gun between 1 and 8 inches from the spraying
surface, depending on the size of the spray pattern that you
need. The closer to the surface you hold the gun, the smaller
the spray pattern.
Keep the gun at right angles to the spraying surface in order to
apply an even coat of material. If you keep the spray gun
moving at a smooth and constant speed, the spray material is
less likely to run or sag.
Begin Trigger
pass gun
Always squeeze the trigger of the spray gun after you begin
your spray pass and release it before the pass is done. For
best results, make the spray passes about 20 inches long and
overlap each pass by 4 or 5 inches. Remember to keep the
gun at right angles to the spraying surface.
Incorrect

Adjusting the Swivel Tube

The adjustable swivel tube on your spray gun lets you get the
most out of the material in your cup no matter at what angle
you need to spray.
If you are holding your spray gun angled down, turn the swivel
tube lever fully clockwise.
NOTE: An arrow on each side of the bridge indicates
the direction that the swivel tube is pointing
when the swivel tube lever is in its fully
clockwise or fully counterclockwise position.
If you are holding the spray gun angled up, turn the swivel
tube lever fully counterclockwise.
4
Correct
Even Release End
stroke trigger pass
Turn
swivel tube lever
fully clockwise
when spraying
down.
© SprayTECH. All rights reserved.