Dräger MS-COM Notice D'utilisation page 4

5 Parts required for assembly
Microphone/earpiece unit
 Earpiece
 Microphone
 Cable with quick-release connector to COM control unit
NOTICE
i
i
During assembly, the corresponding cap which can be
inserted into the microphone is also required
(see chapter 11 on page 7).
Assembly kit
The assembly kit contains:
 Holder
 Protective cap
 Screws and nuts
For the respective order number see chapter 11 on page 7.
COM control unit
NOTICE
i i
The COM control unit is not part of the scope of delivery of
the communication system.
 Connection cable with connector for corresponding radio
 Push-to-Talk button (PTT button)
 Integrated amplifier
6 Assembly
1. Check whether the assembly kit corresponds to the full face
mask used and whether the COM control unit corresponds to
the radio used.
2. Attach the holder of the assembly kit to the left side of the full
face mask
3. Remove the old cap from the full face mask.
4. Insert the microphone/earpiece unit into the holder.
Press and hold the quick-release button until the microphone/
earpiece unit is correctly oriented.
5. Insert microphone into the cap and place the cap on the full
face mask.
In doing so, guide the cable around the connection piece of the
full face mask as follows:
1) See respective Assembly Instructions
4
1)
.