Auto Mode; Slave Mode - Cameo CLPSTTRI12IP Manuel D'utilisation

OPERATION:

AUTO MODE

Press the MODE button repeatedly until "AUTO" appears in the display.
In this operating mode, the light switches automatically between colour
change and colour blending mode. The colour change and/or colour blending
rate is determined by the settings of the respective mode.

SLAVE MODE

Press the MODE button repeatedly until "SLAV" appears in the display.
Connect the slave and master unit with a DMX cable (master unit DMX OUT
- slave unit DMX IN). Now the slave unit follows the master unit.
SELECTING DMX MODE
Press the MODE button repeatedly until one of the four modes appears
in the display (2Ch, 3Ch1, 3Ch2, 6Ch). Press ENTER (1st character blinks)
and then use the UP and DOWN buttons to select the desired DMX mode.
Confirm with ENTER.
SELECTING THE DMX START ADDRESS
Press the MODE button repeatedly until "A" and 3 additional characters
appear in the display. Press ENTER (characters 2, 3 + 4 blink) to use the UP
and DOWN buttons to select the desired DMX start address (A001 - A512).
Confirm with ENTER. Note: In order to be able to use the light in DMX mode,
the DMX start address mode must be set.
12