OPERATION:
STATIC COLOUR
Press the MODE button repeatedly until "Cxxx" appears in the display. Press
ENTER (2nd character blinks) and then use the UP and DOWN buttons to
select the desired colour or the stroboscopic effect ("C1" = red, "C2"
= green, "C3" = blue, "CF" = stroboscopic effect). Press ENTER again
(characters 3 + 4 blink) in order to use the UP and DOWN buttons to set the
brightness (00 - 99) of the selected colour or the stroboscope rate
(00 = stroboscope effect deactivated, 99 = maximum stroboscope rate).
Press ENTER to confirm.
For example: If you set C1, C2, and C3 to "00", all LEDs in the light are off
(blackout). If you set C1 to "99" and C2 and C3 to "00", then the light shines
100% red.
RED
Brightness 00 - 99
GREEN
Brightness 00 - 99
BLUE
Brightness 00 - 99
STROBE
Stroboscope speed 00 - 99
10