Velleman SP500B Mode D'emploi page 6

"ANTI-TAMPER MODE"
When the shock sensor is activated, the intruder will hear a warning tone that tells
him to turn back. If he doesn't listen and the shock sensor picks up more than 3
shocks in 20 seconds, then the anti-theft alarm will activate the siren. Press
transmitter button I to activate this system.
3. DEACTIVATE the shock sensor
The shock sensor can be deactivated at any given time. Activate the alarm then press button II
within 5 seconds. The alarm system deactivates the shock sensor automatically.
F. Manual Deactivation
1. Press transmitter button I.
2. The siren will emit two beeps to indicate that the alarm has been deactivated.
REMARK : 1. DEACTIVATING THE ALARM WHEN IT'S BEEN TAMPERED WITH: If the alarm
has been triggered, then the siren will produce 4 beeps and the parking lights will
flash three times when you want to deactivate the alarm. The red LED will
indicate which zone has activated the alarm.
2. AUTOMATIC REACTIVATION: This alarm system is equipped with an automatic,
passive rearming circuit that will fully reactivate the system if none of the doors
(the dome light should be on and current sensing should be selected) were
opened or if the engine wasn't started within 30 seconds of the deactivation.
G. Panic Alarm
The transmitter can be used as a panic switch to trigger the alarm from a distance in case of
emergency. Hold button I for longer than 3 sec.: the alarm is triggered and the siren starts to
wail. Simply press the transmitter button again to deactivate the panic alarm.
H. Triggering the alarm
When the alarm has been armed for 5 seconds: open a door, the boot or the bonnet, smack the
chassis or the windshield, jack the vehicle up or tow it. The siren and the parking lights will
come on for 30 seconds. The alarm then returns to the armed mode and will be triggered again
if the situation(s) described above persist(s).
I. Switch to deactivate the alarm
The service switch at the back of the central unit enables the owner of the vehicle to suspend all
alarm functions when the car is left on a supervised parking lot or when it is in service.
1. Insert the key in the service switch and put the switch in the ON position. The alarm and
the transmitter no longer work.
2. Restoring normal operation: insert the key in the service switch and put the switch in the
OFF position.
J. Replacing the battery in the transmitter
If the range of your transmitter appears to diminish you may have to replace the battery.
1. Loosen the screw at the back of the transmitter and remove the top plate with a Philips
screwdriver.
2. Remove the old battery.
SP500B 6 VELLEMAN