Velleman SP500B Mode D'emploi page 5

6. Operation
A. Transmitter
1. Press button I once = activate/deactivate alarm
2. Hold button I for 3 seconds = panic alarm
3. Activate the alarm and press button I within 3 seconds = alarm is activated and the shock
sensor is deactivated
4. Hold button II for 2 seconds: the parking lights will flash for 15 seconds and the siren will
produce 3 beeps. This function makes it easy to find the vehicle in a parking lot.
5. Press button II once, then press button I = activate/deactivate alarm without "beep" warning.
6. Press both buttons to enter the programming mode
B. LED Indicator
1. Red LED OFF = system is OFF
2. Red LED flashes fast = system is ON
3. Red LED flashes once + pause = Indicates attempted intrusion detected via the current
sensor
4. Red LED flashes twice + pause = Indicates attempted intrusion detected via the pin switch or
additional sensors that have been installed
5. Red LED flashes three times = Indicates attempted intrusion detected via the shock sensor.
6. Red LED flashes = automatic activation of alarm after 30 seconds.
C. Audible and Visible Alarm Indication
1 beep + parking light = alarm is activated
2 beeps + parking light = alarm is deactivated
4 beeps and parking light = alarm is deactivated and activated again
D. Alarm System
1 siren
2 status engine
3 orange wire
4 door lock interface
5 red LED
6 parking light
E. Manual Activation
1. Press button I on the sender.
2. The siren will emit 1 beep and the system will be fully armed 5 seconds later.
REMARK : ACTIVATE THE SHOCK SENSOR WITH THE REMOTE TRANSMITTER
In parking garages with several floors vibrations can occur frequently. Sometimes
the system can react to these vibrations. Use the remote control to program the
shock sensor.
SP500B
Activate Deactivate
1 tone 2 or 4 beeps
engine OFF
ground
close open
flash OFF
1 flash 2 or 4 flashes
5
Alarm Triggered Panic Function
wails wails
engine OFF engine OFF
ground ground
close
flash flash
flash flash
VELLEMAN