Connecting The Trimmer Unit To The Pole - Makita EN5550SH Manuel D'emploi Et De Sécurité

CONNECTING THE TRIMMER UNIT TO THE
POLE
Important:
Make sure that the engine is turned off, and remove the spark plug cap before
assembling the pole hedge trimmer.
Wear protective gloves!
Secure cutting blades with the blade cover provided when connecting the trimmer
unit to the pole.
- Remove the cap from the shaft.
- Loosen the M5 x 12 screw and M5 x 25 bolt.
- Insert shaft into gear case
NOTE: Make sure that the shaft is completely inserted into the gear case
(approx. 40 mm/1.57").
If you are having trouble inserting the shaft, manually rotate the drive axle a
little and try again.
- Make sure that the shaft is properly inserted and then tighten the M5 x 12 screw
and the M5 x 25 bolt.
Drive axle
40 mm
Shaft
9
M5 x 10 screw
M5 x 25 bolt
Cap