Headphone Connection; Additional Functions; Display Light - Hama DR1500BT Mode D'emploi

6.9 Connecting and playing music files in Bluetooth
mode
Note – Bluetooth connection
• Also follow all instructions and notes regarding
Bluetooth in the operating instructions for the
device you wish to connect. The exact process for
establishing a Bluetooth connection between the radio
and your device can vary.
• Ensure that your device supports the A2DP Bluetooth
profile.
• Take care that Bluetooth is activated on your device.
• Ensure that the radio and your device are not more than
1m apart from each other.
• Press MODE repeatedly until Switch to BT appears on
the display. The radio switches a few seconds later into
the Bluetooth Pairing mode.
• Start the search for Bluetooth devices on your device in
the Bluetooth settings. If the radio is found it will display
on your device as BT speakerN. If you are asked for a
key for pairing, enter 0000.
• Select BT speakerN on your device and run the pairing
process. This may take several seconds. The radio signals
successful pairing by means of a signal tone and by
displaying - Icons on the display.
• After successfully pairing, press SCROLL/OK ► II or begin
playback on your device.
• To pause playback press SCROLL/OK ► II again or the
corresponding pause or stop buttons on your device.
• In order to rewind or forward through music files during
playback press ► ► I or I ◄ ◄, or the corresponding
buttons on your device.
Note – Mobile phones
• Some mobile phones interrupt the Bluetooth
connection when receiving calls. This is not a problem
with your radio, but rather your mobile phone's
specific way of behaving during Bluetooth operation,
which can vary by manufacturer.

7. Additional functions

7.1 Display light

This radio has a display light that can be dimmed to three
different levels.
• Press BACKLIGHT repeatedly until the desired level of
brightness is reached.
7.2 Displaying firmware version of radio
Press and hold INFO longer than 2 seconds in order to
display the current firmware version of your radio.
7.3 Reverting to factory settings
• Connect the enclosed power cable to the 220V input of
your DAB/FM radio.
• Connect the power cable to a properly installed 220V
power socket.
• Press STANDBY to switch on the radio.
• Press and hold MENU until the display shows the
message ‚Press SELECT to confirm reset'.
• Press SCROLL/OK ► II. The display shows the message
‚Restarting...' and then goes into standby mode.
• Switch on the radio as described in section 4.1 and
perform the subsequent steps for setup and station
search.
Warning
• All saved DAB and FM presets are wiped when
reverting to factory settings.

7.4 Headphone connection

On the rear of the radio is a headphone connection (14),
which is suitable for headphones with a 3.5mm stereo jack.
When headphones are being used the built-in speakers are
deactivated automatically.
Warning - high volume
• Always keep the volume at a reasonable level. Loud
volumes, even over short periods, can cause hearing
loss.
7