Signal Strength - Hama DR1500BT Mode D'emploi

• Turn SCROLL/OK ► II, in order to view all located
stations in alphabetical order.
• Press SCROLL/OK ► II to choose a station to play.
6.2 Manual DAB station search
• Press MENU to open the Tune Select menu.
• Turn SCROLL/OK ► II to chose Manual tune and press
SCROLL/OK ► II to confirm the selection (F4).
• Turn SCROLL/OK ► II to scan through the DAB
channels.
The display has a reception range of 5A to 13F and
displays the associated frequencies. (F5)
• Turn SCROLL/OK ► II to select a frequency. The station
name and station group (ensemble/multiplex) are
displayed.
• Press SCROLL/OK ► II to choose a station to play.
6.3 Additional DAB information
A > after the displayed station name indicates that this
station offers additional information.
• Press INFO repeatedly to display additional information
in the following order:
Time/Date:
Time and date are updated automatically by the broadcast
information. If no time/date information is available the
display just shows <TIME/DATE>.
Frequency:
The frequency of the station received is displayed.
Audio bit rate:
The currently received digital bit rate of the received
station is displayed.

Signal strength:

The signal strength of the received station is displayed via
a bar and its length.
DLS:
Dynamic Label Segment displays additional information
from the station about the programme as a scrolling ticker.
Programme type:
The style of the programme received is displayed. If no
programme information is available the display just shows
<Programme Type>.
Ensemble/Multiplex (Group name):
Ensemble/Multiplex is a combination of various stations
that broadcast on a shared frequency. Usually these
stations have something in common in terms of their local
origin, their style of music or the information they provide.
6.4 Automatic FM station search
• Press MODE repeatedly until ‚Switch to FM' is shown
on the display. The display then shows FM and the
current frequency.
• Press and hold SCROLL/OK ► II until the automatic
station search starts.
While scanning the display shows ‚Searching...' (F6). If a
station is found, the search stops and the station plays.
• Start the search again as described above in order to
search for other stations.
5