Vortice LINEO V0 Notice D'emploi Et D'entretien page 14

ALWAYS require connection to
220-240V (or only 230V where
required) single-phase lines.
Any kind of modification shall
be considered as product
tampering and shall nullify the
relative warranty.
• This symbol means that the operation must
be performed by professionally qualified
personnel.
N.B.
• When the appliance is installed at a height
lower than 2.3 m it is obligatory that (fig. 3):
• the frame with safety screen, when the short
duct is connected to the outlet port (to
prevent access).
• the protective grille is fitted when the inlet
port is not ducted (free intake).
• All versions of 100-125-150-160-200-200Q-250Q
appliances are fitted with a safety
overtemperature device.
• Versions of 250-315 appliances are equipped
with a manual-reset safety device to shut down
operation in the event of fault. If the device
cuts in, disconnect the appliance, allow it to
cool, eliminate the cause of the fault (e.g. grille
obstruction, fan fault, duct obstructions), then
reconnect the appliance. If the safety device
trips again, have the appliance checked by
VORTICE*.
*(or an authorized VORTICE dealer if you are outside
the UK-Ireland territory)
Duct and window - wall fan
units
Precautions must be taken to
prevent gas coming from the gas
flue pipe or from other fuel
combustion units from entering
into the room.
Window - wall fan units
Fans have been designed to be
mounted on windows or external
walls.
Units equipped with manual
reset thermal breaker device
In order to avoid any danger of
accidental reset of the thermal
breaker device, units must not
be powered by an external
switch device such as a timer, or
must not be connected to a
14
circuit that is regularly powered
or disconnected from power
utilities.