Electrolux GT200 Notice D'utilisation page 73

Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the SUPER, or af‐
ter changing the tempera‐
ture.
The temperature in the ap‐
pliance is too low/too high.
If your appliance is still not working properly after making the above checks, contact
the nearest Authorised Service Center.
Specify the model and serial number of your appliance when you contact Authorised
Service Center. This will accelerate the support received.
Possible cause
The lid is not closed prop‐
erly or the gasket is de‐
formed/dirty.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The temperature regulator
is not set correctly.
The lid is not closed prop‐
erly.
The products' temperature
is too high.
Many products are stored
at the same time.
The thickness of the frost
is greater than 4-5 mm.
The lid was opened too of‐
ten.
The SUPER function is
switched on.
Products to be frozen are
placed too closely to each
other.
The appliance is positioned
near the heat source.
ENGLISH
Solution
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
Refer to "Control panel/
Temperature regulation"
chapter.
The compressor starts af‐
ter a period of time.
Set a higher/lower temper‐
ature.
Check if the lid closes
properly and the gaskets
are not damaged or dirty.
Allow food to cool to room
temperature before stor‐
ing.
Store less products at the
same time.
Defrost the appliance. Re‐
fer to "Care and cleacning/
Defrosting the appliance"
chapter.
Open the lid only if neces‐
sary.
Refer to "Control panel/
SUPER function" chapter.
Make sure that there is
cold air circulation in the
appliance.
Refer to "Installation/Loca‐
tion" chapter.
73