Electrolux GT200 Notice D'utilisation page 65

It must be possible to
disconnect the appliance
from the mains power
supply. The plug must
therefore be easily
accessible after installation.
3.3 Positioning
This appliance is not intended to be used
as a built-in appliance.
This appliance should be installed in a
dry, well ventilated indoor position.
This appliance is intended to be used at
ambient temperature ranging from 10°C
to 43°C. The correct operation of the
appliance can only be guaranteed within
the specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer
service or to the nearest
Authorised Service Centre.
3.4 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
3.5 Handle installation guide
1. Take out the handle base and 4
screws from the plastic bag.
2. Place the handle in position
according to the picture. Use Phillips
screwdriver to fix the handle base to
the lid.
3. Take out the handle cover from the
plastic bag. To avoid installing the
handle cover upside down check the
cover direction before installation.
4. Push the cover to the front side of the
handle base.
ENGLISH 65