Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cleaning of filter drawer/
heat exchanger
Warning symbol flashes periodically to remind
that filter drawer must be cleaned.
4.7 Starting the program
Press the Start/Stand-by button to start the
program.
Start/Stand-by and Drying indicators turn on to
show that program started.
4.8 Child Lock
The drying machine has a child lock which
prevents the program flow from being
interrupted when the buttons are pressed
during a program. When the Child Lock is
activated, all buttons on the panel except
the On/Off/Program Selection button are
deactivated.
Press the Audible Warning button for 3
seconds in order to activate the child lock.
The child lock has to be deactivated to be
able to start a new program after the current
program is finished or to be able to interfere
with the program. To deactivate the child lock,
keep the same buttons pressed for 3 seconds.
C
NOTE!
•
When the child lock is activated, the child
lock warning indicator on the screen
turns on.
When the child lock is active:
The drying machine runs, or in stand-by state
the indicator symbols will not change upon
changing the position of the program selection
button.
C
NOTE!
•
When the drying machine is operating
and the child lock is activated, double
beep sound is heard when the program
selector switch is turned. If the child lock
is cancelled without turning the program
selector button back to its original
position, the program is terminated since
the program selector button is turned.
88
4.9 Changing the program
after it is started
You can change the program you selected to
dry your laundry with a different program after
the drying machine starts running.
•
For example, Pause the program and
turn the On/Off/Program Selection button
to select the Sprint program in order to
select the Sprinty program instead of Mix.
•
Press the Start/Stand-by button to start
the program.
Adding and removing clothes during stand-by
If you want to add or remove clothes to/from
the drying machine after the drying program
starts:
•
Press the Start/Stand-by button to put
the drying machine in Stand-by state. The
drying operation stops.
•
Open the loading door while in Stand-
by state, and close the door after you
remove or add laundry.
•
Press the Start/Stand-by button to start
the program.
C
NOTE!
•
Adding laundry after the drying operation
starts may cause the dried laundry inside
the drying machine to mix with wet
laundry and leave the laundry damp at
the end of operation.
•
Adding or removing laundry during drying
may be repeated as many times as you
wish. But this operation continuously
interrupts the drying operation, and thus
increases program duration and energy
consumption. So, it is recommended to
add laundry before the program starts.
•
If a new program is selected by turning
the program selection button while
the drying machine is in stand-by, the
running program terminates.
Dryer / User Manual
Publicité
Table des Matières
