Seca 872 Mode D'emploi Et Garantie page 14

6. What do I do if ...
... no weight is displayed when there is a load on the scale?
– Is the scale switched on?
– Is the switch inside the battery compartment in position "ON"?
– Check the batteries.
... the scale keeps switching on, while being transported, for example?
– The vibration switch has been activated by the movement of the scale. Due to the very
low energy requirement of the scale, the service life of the batteries will not be impaired.
For longer journeys, you can push the switch inside the battery compartment in posi-
tion "OFF" if necessary.
... the scale displays a weight after being transported or after new batteries have
been put in?
– Wait until the scale switches off automatically after 2 minutes. The scale will then work
normally again.
... 0. 0 does not appear before weighing?
– Start the scale again after it switches off automatically - there should not be any load
on the scale.
----
... appears instead of
– Start the scale again after it switches off automatically - there should not be any load
on the scale.
... weight is displayed in a different unit?
– If necessary, switch the weight display (see "Switching the weight display" on
page 12).
... one segment is illuminated constantly or not at all?
– The relevant segment has a fault. Inform Servicing.
... the display shows
– Battery voltage is running low. Change the batteries in the next few days.
batt
... appears in the display?
– Batteries are empty. Put in new batteries.
St0p
... appears in the display?
– Maximum load has been exceeded.
... the display flashes?
– Take the load off the scale and start the scale again. Wait until
weigh again.
... the display
– The ambient temperature of the scale is too high or too low. Place the scale in an
ambient temperature between +10 °C and +40 °C. Wait about 15 minutes for the
scale to adapt to the ambient temperature and then weigh again.
... the display E and a number appear?
– Start the scale again after it switches off automatically. The scale will then work nor-
mally again. If this is not the case, inform Servicing.
14
0. 0
before weighing?
?
appears?
appears and then
0. 0