Maintenance And Cleaning; What To Do In Case Of A Problem - BORETTI BIK-65 Notice D'emploi

Maintenance and cleaning

Switch-off the appliance before cleaning.
Do not clean the hob if the glass is too hot due
to risk of burn.
• Remove light marks with a damp cloth with
washing up liquid diluted in a little water. Then
rinse with cold water and dry the surface
thoroughly.
• Highly corrosive or abrasive detergents and
cleaning equipment likely to cause scratches
must absolutely be avoided at all times.
• Do not ever use any steam-driven or pres-
sured appliance.

What to do in case of a problem

When the symbol [ E 4 ] appears :
• The table must be reconfigured. Please implement the following steps :
I) Important : before you start, make sure there is nothing on the hob
II) Disconnect the appliance from the power supply by removing the plug, fuse or turning the
circuit breaker off
III) Reconnect the table to the grid
IV) Procedure : take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
* start the procedure within 2 minutes after reconnecting the hob to the grid
* don't use the [ O/I ] touch
1
68
C
D
• Do not use any object that may scratch the
ceramic glass.
• Ensure that the pan is dry and clean. Ensure
that there are no grains of dust on your ce-
ramic hob or on the pan. Sliding rough pans
across the glass will scratch the surface.
• Spillages of sugar, jam, jelly, etc. must be
removed immediately to prevent the surface
being damaged.
B
2 3
Slider
A