Maintenance And Cleaning - BORETTI BIZ-4 Mode D'emploi

VI) Second step: new setup
1) Take a pot with a ferromagnetic bottom with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ C ] display
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected cooking zone is now configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Note: .....Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.

Maintenance and cleaning

Switch-off the appliance before cleaning.
Do not clean the hob if the glass is too hot due
to risk of burn.
• Remove light marks with a damp cloth with
washing up liquid diluted in a little water. Then
rinse with cold water and dry the surface
thoroughly.
• Highly corrosive or abrasive detergents and
cleaning equipment likely to cause scratches
must absolutely be avoided at all times.
• Do not ever use any steam-driven or pres-
sured appliance.
• Do not use any object that may scratch the
ceramic glass.
• Ensure that the pan is dry and clean. Ensure
that there are no grains of dust on your ce-
ramic hob or on the pan. Sliding rough pans
across the glass will scratch the surface.
• Spillages of sugar, jam, jelly, etc. must be
removed immediately to prevent the surface
being damaged.
)
2
D
EN
37