Items Supplied; Intended Use; Safety Instructions - EINHELL EHM 1300 Mode D'emploi

Anleitung EHM_1300_SPK1:_
1. Layout
1 On/Off switch
2 Slide block
3 Push stick
4 Hand crank
5 Chip extractor
6 Parallel stop
7 Clamping lever
8 Mounting for planing knife cover
9 Setting knob for the chip depth
10 Workpiece support
11 Rubber foot
12 Planing knife cover
13 Feed table
14 Planing table
15 Blade adjustment block
16 Allen key
17 Wrench
18 Scale
19 Pointer
20 Thicknessing table
21 Knife
22 Latch
23 Knife block
24 Anti-kick claws
25 Knife cover plate
26 Tipping guard bar
27 Chip extractor adapter, 100 mm diameter
28 Chip extractor adapter, 35 mm diameter
29 Scale
30 Pointer
31 Locking knob
32 Locking knob
33 Locking knob
34 Securing screw chip extractor
35 Overload switch

2. Items supplied

Plane
Assembly tool
Push stick
Slide block (2x)

3. Safety Instructions

Please refer to the booklet included in delivery for
the safety instructions.
18.12.2006 8:20 Uhr Seite 11
4. Important information
Always switch off the On/Off switch (1) and pull
the mains plug out of the socket before carrying
out any maintenance work or having the machine
serviced. (Fig. 1)
Check at regular intervals that the knife (21) and
latch (22) are firmly attached in the knife block
(23). (Fig. 15)
The knives (21) must not project more than a
maximum of 1.1 mm out of the knife block (23).
(Fig. 15)
Never remove the safety covers on the machine
except for servicing and repair work.
The safety covers must be intact at all times.
Each time you use the machine, first fasten and
secure the safety covers at the points provided.
Connect a dust extractor to the sawdust extractor
(5) if you use the machine in an enclosed area.
(Fig. 1)
Make sure that the anti-kick claws (24) work
correctly. (Fig. 13)
Always wear eye protection.
Never cut concavities, tenons or shapes.
This machine will provide the performance
described in these operating instructions if it is
correctly assembled, used, maintained and
repaired. The machine must be inspected at
regular intervals. Never use any defective parts,
including power cables. Damaged, missing, worn
and deformed parts must be replaced immediately.
Only qualified personnel are permitted to carry out
repairs or replace parts. No modifications may be
made to the machine or any machine parts if these
would result in the machine differing from the
standard specifications.

5. Intended use

The surfacing and thicknessing plane is designed
for the surfacing and thicknessing of all types of
whole pieces of square, rectangular or chamfered
converted timber.
The machine is to be used only for its
prescribed purpose.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. There is a risk of the following injuries in
connection with the required operation of the
machine.
Fingers or hands coming into contact with the
knife block in areas which are out of view.
GB
11