Ryobi CCC-1801M Manuel D'utilisation page 11

GB
F D
GENERAL SAFETY RULES
Under abusive conditions, liquid may be ejected
■
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
SERVICE
Have your power tool serviced by a qualified repair
■
person using only identical replacement parts.
This will ensure that the safety of the power tool
is maintained.
SPECIFICATIONS
Voltage
No load speed
Battery pack (Not Included)
Charger (Not Included)
Triangle base dimension
Orbital diameter
Weight
DESCRIPTION
1. Heavy-duty scrubbing pad (red)
2. Light scrubbing pad (white)
3. Polishing pad (gray)
4. Sanding sheet
5. Hook-and-loop pad
6. On/Off switch
7. Latch
8. Battery Pack (Not Included)
9. Fuzzy side
OPERATION
WARNING
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second issufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating tools. Failure to
do so could result in objects being thrown into
your eyes, resulting inpossible serious injury.
E I P NL
18 V
1
11000 min-
BPP-1817M BPP-181M
BC-1815S
140 x 80 mm
1.8 mm
0.83 kg
S DK N FIN GR
English
APPLICATIONS
You may use this tool for the following purposes:
Sanding on wood surfaces
■
Removing rust from and sanding steel surfaces
■
Polishing and scrubbing porcelain and metal
■
TO INSTALL BATTERY PACK (NOT INCLUDED)
(Fig. 2)
BC-1800
Place the battery pack in the sander. Align the raised
■
rib on the battery pack with the groove inside the
sander, then slide the battery pack into the sander.
Make sure the latches on each side of your battery
■
pack snap into place and the battery pack is secured
in the sander before beginning operation.
Make sure the latches on each side of the battery
■
pack snap into place and the battery pack is secured
in the drill before beginning operation.
TO REMOVE BATTERY PACK (NOT INCLUDED)
Locate the latches on the side of the battery pack
■
and depress them to release the battery pack from
the sander.
Remove battery pack from the sander.
■
7
RO
H CZ RUS
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING
Always be sure the switch is in the OFF (O)
position before installing the battery pack. Failure
to do so could cause accidental starting, leading
to serious personal injury.
CAUTION
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the bottom
of the drill and latches into place properly.
Improper installation of the battery pack can
cause damage to internal components.
WARNING
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use orcarrying at your side.
HR
PL SLO TR