Husqvarna CL400 Manuel D'utilisation page 13

Problem
The engine does not start
The cutter does not rotate even if the
related lever is engaged
The cutter continues to rotate when
the lever is disengaged
The product does not opearate cor-
rectly
The product does not move when the
forward lever is engaged
it is to hard to steer the product
The head of the cutter does not slide,
preventing the replacement of the
cutter
The insulation of the cable laid down
is damaged
1394 - 002 - 27.11.2019
Cause
There is no fuel in the fuel tank.
The fuel tap is closed.
When the engine is cold, the gas lever is not moved to START position.
When the engine gets warm, the gas lever is moved START position.
The gas lever is moved to STOP position.
The fuel does not reach the carburettor.
The air filter is clogged.
The vent hole on the fuel cap is closed by impurities.
The spark plug is defective.
The belt is worn out.
The belt has slipped out of the pulleys.
The lever does not stretch the belt properly.
The brake pulley is not engaged.
The brake lining does not rest on the pulley side.
The brake lining is consumed.
The cutter is too worn.
The cutter is broken or not installed.
The air filter is clogged. In this case, blow the air filter with compressed air or
replace it with a new one.
The fuel is insufficient.
The engine oil level is lower than the minimum limit.
The cable is slackened.
The transmission belts are worn.
The chain is broken or slacken.
The clutch discs inside the transmission housing are worn.
The handlebar is slacken.
There are residues in the unit.
There is oxide formed inside the system.
The outlet spout of the cable on the blade is damaged.
The tube that contains the cable and which is part of the blade is dirty.
13