Maintenance Schedule - Husqvarna 125B Manuel D'utilisation

2. Move the choke control to 1/2 position.
3. Pull the starter rope handle quickly while you pull
the throttle trigger until the engine runs.
4. Move the choke control to the OFF CHOKE
(opened) position.
To stop the engine
• Push and release the engine STOP switch. The
switch automatically returns to the ON position.
Wait 7 seconds before you try to restart the
product to make sure that the switch resets.
To use a nozzle
• Use the standard nozzle when precision and high
air stream concentration is necessary. (Fig. 29)
• Use the high velocity nozzle when a wider
airstream and large air velocity is necessary.
(Fig. 30)
To adjust the blower nozzle
1. Twist the nozzle to the left to disengage the
bayonet mount.
2. Move the nozzle to applicable position.
3. Twist the nozzle to the right until you feel a click.
To vacuum
Before you vacuum, put on the necessary safety
equipment.
WARNING:
collection bag is not damaged and that
the zipper is closed before use. Do not
WARNING:
the safety chapter before you clean,
repair or do maintenance on the product.

Maintenance schedule

Make sure that you obey the maintenance schedule.
The intervals are calculated from daily use of the
product. The intervals are different if you do not use
the product each day. Only do the maintenance work
that is found in this manual. Speak to an approved
service center about other maintenance work not
found in this manual.
Daily maintenance
• Clean the external surfaces.
• Examine the speed control and the throttle
trigger function. Replace damaged parts.
• Examine the stop switch. If it is necessary,
replace it.
• Examine the idle speed.
• Clean the air filter. If it is necessary, replace it.
12
Make sure that the
Maintenance
Read and understand
use a bag that is damaged. This
prevents injury caused by flying debris.
Left hand operation increases the risk.
Do not let your body touch the exhaust
outlet area.
WARNING:
if the inlet cover is open or damaged
(except if the vacuum tube is fitted).
• During operation of the blower the collection bag
must be held by the shoulder strap. The strap
must be worn on the top of the shoulder.
• Start the blower. Obey the instructions in the
start and stop section
11 . Read the safety instructions Safety on page
7 .
To empty the collection bag
WARNING:
collection bag. Make sure that it is not
damaged and that the zipper is closed
before use. Do not use a damaged bag.
There is a risk of injury because of flying
debris. Be careful if left hand operation is
applied. Do not touch the exhaust outlet
area.
1. Stop the product.
2. Open the zipper on the side.
3. Empty the collection bag.
4. Close the zipper.
• Make sure that the inlet cover can be locked in
closed position. Make sure that the impeller is
clean.
• Tighten all nuts and screws.
• Make sure that the housings are free of cracks.
• Make sure that the collection bag is not damaged
and that the zipper works. Replace the bag if
necessary.
Weekly maintenance
• Examine the condition of the starter device, the
starter rope and the tension spring. Replace all
damaged parts.
• Examine the condition of the air intake at the
starter device. Remove debris if the air intake is
clogged.
• Clean the external side of the spark plug.
Remove it and examine the electrode gap. Adjust
the distance to 0.6 mm (0.024 in) or replace the
spark plug.
• Clean the blades on the impeller.
Do not start the blower
To start and stop on page
Always examine the
237 - 011 - 15.11.2021