Maintenance; Maintenance Schedule - Husqvarna 350iB Manuel D'utilisation

3. Continue to operate the product without the power
trigger pushed.
4. Push the cruise control button again to stop the
cruise control function.
To temporarily increase the airflow
1. Start the product. Refer to
page 11 .
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.

Maintenance

Clean the outside of the machine with a clean and dry cloth. Never use water.
Keep handles dry, clean and free from oil and grease.
Make sure that the power button works correctly and is not damaged.
Make sure the power trigger is functioning properly with regard to safety.
Check that nuts and screws are tight.
Check that the battery is intact.
Check the battery's charge.
Check that the release buttons on the battery works and locks the battery into
the machine.
Check that the battery charger is intact and functional.
Check that all connections are intact and free from dirt.
Check the connections between the battery and the machine and also check the
connection between battery and the battery charger.
12
To start the product on
Maintenance
Before you do any
2. Push the power boost button to get the maximum
airflow. The LED comes on.
3. Release the power boost button to use the product
with the initial air flow.

Maintenance schedule

WARNING:
you do maintenance.
The following is a list of the maintenance steps that you
must do on the product.
Remove the battery before
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
1776 - 003 - 20.04.2022
X