Safety Instructions For Maintenance; Assembly - Husqvarna 350iB Manuel D'utilisation

• Do not put objects into the cooling slots of the
battery charger.
• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Use approved wall sockets that are not damaged.

Safety instructions for maintenance

WARNING:
warning instructions that follow before you
do maintenance on the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Speak to
your servicing dealer for maintenance and servicing
of a larger extension.
Introduction
This section describes how to assemble and adjust the
product.
WARNING:
product, read the safety chapter and the
assembly instructions.
To assemble the blower tubes
Note:
Apply water-based lubricant on the end of the
tubes to make assembly easier.
• Attach the lower tube to the upper tube until the tab
(B) goes into the hole (A). Make sure that the lower
tube and the upper tube are locked together.
A
• For higher air speed, attach the high speed nozzle to
the lower tube.
1776 - 003 - 20.04.2022
Read the

Assembly

Before you assemble the
B
• Keep all nuts, bolts and screws tight to be sure the
product is in safe working condition.
• Replace worn or damaged parts.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on
the product. If not all checks in this operator's
manual are approved after maintenance, speak to
your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
SAVE THESE
INSTRUCTIONS
To attach the scraper tool
The scraper tool can be used to loosen leaves and other
unwanted material for easier cleaning.
• Attach the scraper tool to the lower tube until the
tab (A) goes into the hole (B). Make sure that the
scraper tool and the tube are locked together.
To install the battery charger on the
wall
CAUTION:
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
B
A
Do not use an electric
9