Operation - Husqvarna 350iB Manuel D'utilisation

1. Install the battery charger on the wall with the 2
screws (B). Use wall plugs (A) if it is necessary.
B
B
C
Introduction
WARNING:
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the air inlet for dirt and cracks. Use
a brush and clean off grass and leaves from the
product.
2. Make sure that the product works correctly.
3. Do a check of all nuts and screws and make sure
that they are tight.
To connect the battery charger
WARNING:
charger in ambient temperatures between
5°C/41°F and 40°C/104°F.
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded power outlet. The LED on
the battery charger flashes red 1 time and green 1
time.
10
A
D

Operation

Read and understand the
Only use the battery
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger and a
mains socket.
To charge the battery
CAUTION:
the battery charger and the terminals on the
battery are clean and dry. Do not put the
battery in the battery charger if it is dirty or
wet.
1. Connect the battery charger to a power outlet. The
charging LED flashes red 1 time and green 1 time.
CAUTION:
charger to a power outlet with the
voltage and frequency specified on the
rating plate.
2. Connect the battery to the battery charger. The
charging LED comes on.
3. Remove the battery from the battery charger when it
is fully charged. Push the battery indicator button for
battery status. When all the LED indicators come on,
the battery is fully charged.
4. Pull the power plug to disconnect the battery charger
from the power outlet. Do not pull the power cord.
To connect the battery to the product
WARNING:
original batteries in the product.
Make sure that the battery,
Only connect the battery
Only use Husqvarna
1776 - 003 - 20.04.2022