Stop Switch; Fuel Safety; Safety Instructions For Maintenance - Husqvarna 125B Manuel D'utilisation

• Make sure that you have a first aid kit near.
Protective devices on the product
• Make sure that you regularly do the maintenance
to the product.
• The life of the product increases.
• The risk of accidents decreases.
Let an approved dealer or an approved service
center regularly examine the product to do
adjustments or repairs.
• Do not use a product with damaged protective
equipment. If the product is damaged, speak to
an approved service center.

Stop switch

Start the engine. Make sure that the engine stops
when you move the stop switch to the stop position.
(Fig. 16)
Muffler
WARNING:
muffler if it is hot. The muffler is very hot
while the engine runs and after it stops.
If you touch the muffler, it can cause
burns.
• Do not use an engine with a damaged muffler. A
damaged muffler increases the noise level and
the risk of fire. Keep a fire extinguisher near.
• Examine regularly that the muffler is attached to
the product.
• Do not touch the engine or the muffler when then
engine is on. Do not touch the engine or the
muffler for a while after the engine stops. Hot
surfaces can cause injuries.
• A hot muffler can cause a fire. Be careful, if you
use the product near flammable liquids or fumes.
• Do not touch the parts in the muffler, if the
muffler is damaged. The parts can contain some
carcinogenic chemicals.
• Some blower models are have a spark-arresting
screen.Clean and replace the screen at specified
intervals. See the Maintenance section
Maintenance on page 12 ).
(
(Fig. 17)

Fuel safety

• Do not start the product if there is fuel or engine
oil on the product. Remove the unwanted fuel/oil
and let the product dry. Remove unwanted fuel
from the product.
• If you spill fuel on your clothing, change clothing
immediately.
• Do not get fuel on your body, it can cause injury.
If you get fuel on your body, use a soap and
water to remove the fuel.
237 - 011 - 15.11.2021
Do not touch the
• Do not start the engine if you spill oil or fuel on
the product or on your body.
• Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
• Be careful with fuel. Fuel is flammable and the
fumes are explosive and can cause injuries or
death.
• Do not breathe in the fuel fumes, it can cause
injury. Make sure that there is a sufficient airflow.
• Do not smoke near the fuel or the engine.
• Do not put warm objects near the fuel or the
engine.
• Do not add the fuel when the engine is on.
• Make sure that the engine is cool before you
refuel.
• Before you refuel, open the fuel tank cap slowly
and release the pressure carefully.
• Do not add fuel to the engine in an indoor area.
Not sufficient airflow can cause injury or death
because of asphyxiation or carbon monoxide.
• Tighten the fuel tank cap carefully or a fire can
occur.
• Move the product at a minimum of 3 m (10 ft)
from the position where you filled the tank before
a start.
• Do not put too much fuel in the fuel tank.
• Make sure that a leak cannot occur when you
move the product or fuel container.
• Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
sure that the storage area does not contain an
open flame.
• Only use approved containers when you move
the fuel or put the fuel into storage.
• Empty the fuel tank before long-term storage.
Obey the local law on where to dispose fuel.
• Clean the product before long-term storage.
• Remove the spark plug cable before you put the
product into storage to make sure that the engine
does not start accidentally.

Safety instructions for maintenance

WARNING:
can result in serious engine damage or
in serious injury.
The owner is responsible for the performance of all
necessary maintenance as specified in the
operator's manual. Disconnect the spark plug before
maintenance. Do not disconnect the spark plug
before carburetor adjustments.
Incorrect maintenance
9