To Operate The Product; Maintenance; Maintenance Schedule - Husqvarna 550iBTX Manuel D'utilisation

To operate the product

1. Push the power trigger to select the optimal airflow
for your work.
2. Push the Cruise control button to set the selected
airflow, the LED comes on.
Introduction
WARNING:
do any maintenance work you must read
and understand the safety chapter.

Maintenance schedule

Maintenance

Clean the external surfaces of the product with a clean and dry cloth. Do not use
water.
Keep the handles dry and clean. Remove oil or grease.
Make sure that the Start/Stop button operates correctly and is not damaged.
Make sure that the power trigger operates correctly.
Make sure that nuts and screws are tight.
Make sure that the release buttons on the battery operates correctly and locks
the battery into position.
12
3. Continue to operate with the selected airflow. It is not
necessary to push the power trigger.
4. To increase the airflow, push the power trigger.
When the power trigger is released, the airflow goes
back to the airflow that was set in step 2.
5. Release the power trigger and push the Cruise
control button to stop the Cruise control function.
To increase the airflow to maximum
1. Start the product. Refer to
page 11 .
2. Push the Boost mode button to enable maximum
airflow when the power trigger is pushed. The LED
comes on to show that the Boost mode function is
on. The Boost mode function has no time limit.
3. Push the Boost mode button again to stop the Boost
mode function.
Maintenance
Before you
To start the product on
Daily Weekly Monthly
X
X
X
X
X
X
790 - 006 - 13.03.2020