Starting And Stopping; Check Before Starting; Connect Battery To The Machine - Husqvarna 320iB Manuel D'utilisation

Check before starting

Li-ion Li-ion
• Check the product for dirt and cracks. Clean off grass
and leaves from the engine using a brush. Gloves
should be worn when necessary.
• Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
• Only use the machine for the purpose it was intended
for.

Connect battery to the machine

• Make sure to use fully charged batteries. Use only a
Husqvarna original battery in your machine. See
technical data.
• Insert the battery in the machine. The battery should
slide easily into the battery holder on the machine. If
the battery does not slide in easily, it is not being
inserted correctly.
• Press on the lower part of the battery and push it in as
far as it will go into the battery compartment. The
battery will lock itself into place when you hear a click.
Make sure the latches snap in place properly.
NOTE!
Make sure to switch OFF the machine when changing
battery.
14 – English

STARTING AND STOPPING

Starting and stopping
WARNING! Make sure no unauthorised
!
persons are in the working area,
otherwise there is a risk of serious
personal injury. The safety distance is 15
meters (50 ft.).
Starting
• Activate the machine by moving the ON/OFF switch
lever to position ON.
• Use the power trigger to control the speed.
Stopping
• Stop and deactivate the machine by releasing the
Power trigger and move the ON/OFF switch lever to
position OFF.
• Remove the battery from the machine by pressing the
two release buttons and pulling out the battery.
IMPORTANT! Always remove the battery to prevent the
machine being started by accident.