Assembly - Husqvarna 550iBTX Manuel D'utilisation

professional repairs and servicing available for your
product.
• Only use original spare parts.
Introduction
WARNING:
understand the safety chapter before you
assemble the product.
To assemble the tube and handle on
the product
1. Put the clamp (B) on the flexible tube (C) and attach
the flexible tube to the blower outlet (A).
B
A
2. Make sure to put the clamp screw (D) as the
illustration shows. Tighten the screw.
3. Attach the transport strap (O) to the guide track of
the joint swivel (H).
O
790 - 006 - 13.03.2020

Assembly

Read and
C
D
H
SAVE THESE
INSTRUCTIONS
4. Put the clamp (B) on the flexible tube (C) and attach
the joint swivel (H).
B
C
5. Make sure to put the clamp screw (D) as the
illustration shows. Tighten the screw.
6. Align the knobs (J) to each side of the joint swivel
(H).
7. Attach the control handle (I) to the guide track (K) of
the joint swivel (H). Make sure that the screw on the
control handle is on the bottom side of the control
pipe.
K
J
H
8. Tighten the screw on the control handle fully.
9. Connect the intermediate pipe (L) to the joint swivel
(H). Make sure that the knob (J) aligns with the guide
track of the intermediate pipe.
L
H
J
10. Turn the intermediate pipe fully to lock the control
pipe and the intermediate pipe.
H
D
I
M
N
9