Assembly - Husqvarna Système de ramassage 52 Manuel Du Propriétaire

INSTALLING DRIVE PULLEY
1. Remove the discharge chute from the deck. (Deck
configuration will vary by size and model)
2. Lower deck to the lowest cutting position.
3. Remove the right hand (discharge side) belt cover
from the deck.
4. Relieve the tension from the deck belt and remove
from the center deck pulley.
(See Operator Manual if necessary)
5. Remove the nut securing the right hand deck
pulley to the spindle.
6. Install drive pulley included in collection system kit
on top of the current deck pulley.
Drive Pulley
7. Reinstall the nut on the spindle and torque to 55-75
ft/lbs.
8. Reinstall the deck belt.
TRIMMING BLOWER
1. Place blower assembly on secure table or stable
surface.
2. Remove the bolts securing the rear mount bracket.
3. Using the hacksaw, trim the blower housing along
the recessed grooves.
4. Reinstall the rear mount bracket with previously
removed bolts.

ASSEMBLY

Belt Cover
Rear Mount
Bracket
MOUNTING BLOWER ASSEMBLY
1. Position blower over the discharge tabs on the
deck and set blower onto the deck.
2. Be sure the blower is sitting flush against the
outside of the deck.
Rear Mount Bracket
Contact Area
3. Install the front mount bracket to the deck with the
clevis pin and hairpin supplied with the kit.
Outer Pulley
Cover
Trim Line
Hairpin
Clevis Pin
5