CHUTE SUPPORT
1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two 3/8" holes
into bagger hood.
Upper Chute Support
3. Secure upper chute support to hood with hex bolts,
washers and nyloc nuts.
8
ASSEMBLY
COVER ASSEMBLY
NOTE: For ease of assembly, you may wish
assistance from another person for mounting the cover
assembly to mower.
1. Lift and rotate cover to align the cover brackets with
support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
CONTAINER INSTALLATION
1. Install containers on support frame, overlapping
containers at center tube.
Flex Trim
2. Close cover and lock latch handle over support
tubes.
NOTE: One container should always overlap the other
container at the center tube.