TEFAL CLIPSO Modulo 2 Guide De L'utilisateur page 16

TEFAL answers your questions
Problems
If you cannot close
the lid:
If the pressure
cooker has heated
up under pressure
with no liquid
inside:
If the pressure
indicator did not
rise and nothing
escapes from the
valve during
cooking:
If the pressure
indicator has risen
but still nothing
escapes from the
valve during
cooking:
12
• Check that the Open knob (E) is pressed down.
• Check the way the seal is fitted, see the "Cleaning and
Maintenance" heading.
• Have your pressure cooker inspected by a TEFAL Ap-
proved Service Centre.
• This is normal for the first few minutes.
If the problem persists, check that:
- The heat source is high enough, if not, increase it.
- The amount of liquid in the pressure cooker is suf-
ficient.
- The operating valve is in position
- Your pressure cooker is properly closed.
- The seal and the pressure cooker edge have not
been damaged.
- The seal is properly fitted, see the "Cleaning and
Maintenance" heading.
• This is normal for the first few minutes.
If the phenomena persists, place your appliance
under a stream of cold water until the pressure pre-
sence indicator drops down.
Clean the operating valve
release conduit
valve flap moves without difficulty
Recommendations
- Fig. 15
- Fig. 16
and check that the safety
1 2
or .
and the steam
- Fig. 17
.