Sony SU-WL500 Manuel D'installation page 23

D: Portrait, +20° leaning
Mounting Hook
2
Firmly secure the LCD Monitor
and the Base Bracket using the
screws supplied with SU-WL500
(+BVST4 × 12).
C: Portrait, no leaning
D: Portrait, +20° leaning
Base Bracket
• When using an electric screwdriver, set the torque
Screw
(+BVST4 × 12)
Screw
(+BVST4 × 12)
Note
setting to approximately 1.5 N·m {15 kgf·cm}.
WARNING
Be sure to tighten the securing screw firmly.
If you fail to do so, the LCD Monitor may fall
when it is pushed upward and cause injury.
23
(GB)