Sony SU-WL500 Manuel D'installation page 12

3
Adjust the angle of the
Mounting Hook with the
supplied hex key.
Perform following  and . Make sure that
screw  firmly secures the arm base of the
Mounting Hook (both left and right).
 Remove the 2 screws  from the arm base
of the Mounting Hook (both left and right)
and determine the screw holes for the angle
(20°) you plan to change to.
 Fit screw holes of the upper arm  and
lower arm  in an adequate angle, put
screws removed in step  into the holes,
then secure both arms.
Hex key
Note
• Make sure that the adjusted angle of both arms are
the same.
• Make sure that both arms are screwed in securely.
CAUTION
• Be careful not to get your fingers caught while
adjusting the angle.
12
(GB)
4
Connect the AC power cord
(mains lead) and the connecting
cable(s) supplied with the LCD
Monitor to the LCD Monitor.
Connect the AC power cord (mains lead) and the
connecting cable(s) to the connectors on the
rear of the LCD Monitor. For details on
connecting the AC power cord (mains lead) and
the connecting cable(s), refer to the instruction
manual of the LCD Monitor.
Note
• You cannot connect the cables to the LCD Monitor
after installing it on the Base Bracket.
• Subcontract the cable routing in the wall to a
licensed contractor.
5
Detaching the Table-Top Stand
from the LCD Monitor.
 Remove one side of the Table-Top Stand at a
time. Firmly hold the Table-Top Stand
securely with both hands while the other
people lift up the LCD Monitor.
 Repeat the previous step and remove the
other side of the Table-Top Stand.