Before Use; Operation - Hitachi WR 12DM Instructions De Sécurité Et Mode D'emploi

BEFORE USE

Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.

OPERATION

1. Using the convenient hook
The convenient hook can be installed on the right
or left side and the angle can be adjusted in 5 steps
between 0 and 80.
(1) Operating the hook
(a) Pull out the hook toward you in the direction of
arrow (A) and turn in the direction of arrow (B).
(Fig. 5)
(b) The angle can be adjusted in 5 steps (0°, 20°, 40°,
60°, 80°).
Adjust the angle of the hook to the desired
position for use.
(2) Switching the hook position
CAUTION:
G If the tool falls, there is a risk that malfunction and/
or physical damage can occur. It is recommended
that you also use fall-preventing wires, etc.
G Incomplete installation of the hook may result in
bodily injury when used.
(a) Securely hold the main unit and remove the
screw using a slotted head screwdriver or a
coin. (Fig. 6)
(b) Remove the hook and spring. (Fig. 7)
(c) Install the hook and spring on the other side
and securely fasten with screw. (Fig. 8)
NOTE:
Pay attention to the spring orientation. Install
the spring with larger diameter away from you.
(Fig. 8)
All manuals and user guides at all-guides.com
English
Convenient Hook
Fig. 5
Fig. 6
Spring
Fig. 7
Larger diameter
faces away
Fig. 8
15