Installing/Removing The Unit - Kenwood KDC-X996 Guide De Démarrage Rapide

Installing/Removing the unit

non-Japanese cars
Bend the tabs of the mounting sleeve
with a screwdriver or the like and
attach it in place.
⁄
• Make sure that the unit is installed
securely in place. If the unit is unstable, it
may malfunction (for example, the sound
may skip).
Japanese cars
1. Remove the hard rubber frame with
reference to <Removing the hard rubber
frame>.
2. Align the holes in the unit (two locations
on each side) with the vehicle mounting
bracket and secure the unit with the
accessory screws.
T
N
3
8 mm
MAX.
ø5mm
Accessory3...for Nissan car
Accessory4...for Toyota car
14 | Quick Start Guide
N
T/N
T
T: Toyota cars
N: Nissan cars
4
8mm
MAX.
ø5mm
Removing the hard rubber frame
1. Engage the catch pins on the removal
tool and release the two locks on the
upper part of frame.
Lift up and pull the frame forward as
shown in the figure.
Removal tool (Accessory
2. When the upper part of frame is
removed, remove the lower part of
frame.
⁄
• The frame can be removed from the
bottom side in the same manner.
Removing the Unit
1. Remove the hard rubber frame with
reference to <Removing the hard rubber
frame>.
2. Detach the faceplate.
3. Insert the two removal tools deeply into
the slots on both sides as shown.
4. Lower the removal tool toward the
bottom, and then pull out the unit
halfway while pressing the removal tool
towards the inside.
¤
• Be careful to avoid injury from the catch
pins on the removal tool.
5. Pull the unit all the way out with your
hands, being careful not to drop it.
Catch
Lock
)
2
Accessory
2