Resetting Thermal Protection - Waring Commercial BIG STIX WSB50 Guide D'utilisation

With unit unplugged, align the tube assembly to Power Pack and turn it a
quarter of a turn to lock into place. Follow arrows on the tube assembly.
OPERATION:
1. Plug unit into outlet.
2. Plunge the Immersion Blender into the pot. DO NOT SUBMERGE MORE
THAN 3/4 OF THE SHAFT LENGTH.
3. The Immersion Blender has 2 switches. The safety switch is located on
the top of the handle and the power trigger switch is located on the inner
handle. To start unit, press the safety switch and the power trigger switch
simultaneously. The safety switch will only need to be pressed once to
start the unit. You do not need to hold down the safety switch for the unit
to continue running; however, the unit will remain ON as long as the power
trigger switch is depressed.
4. Select the desired speed by turning the speed knob. Speed ranges from
1, the lowest speed, to 9, the highest speed.
5. Use the cord wrap knob as a second handle for stability and safety.
6. Angle the Immersion Blender slightly and start to stir while keeping the
blade off the bottom of the pot so that preparation will not be sucked up by
the vortex action.
7. Remove the Immersion Blender from the pot after blender has come to a
complete stop.
NOTE: Always unplug Immersion Blender after each use. Keep the
appliance out of reach of children.
• To prevent splattering, be careful never to remove the Immersion Blender
from liquid while in operation.
• When a recipe calls for ice, use crushed ice (not whole cubes) for
best results.
NOTE: If a piece of food becomes lodged in the protective blade guard
surrounding the metal blade, follow the safety instructions below:
1. Release the power trigger and unplug the unit from the electrical outlet.
2. Remove the shaft from the Power Pack.
3. Use a spatula to carefully remove the food lodged in the blade guard.
The blade is very sharp. DO NOT USE YOUR FINGERS TO REMOVE
LODGED OBJECTS.
4. You may now reattach shaft, plug unit back in, and continue blending.
The immersion blender you have purchased is equipped with an Automatic
Reset Switch to protect the motor from overheating. If your immersion
blender stops running under heavy use, press the power switch to the
OFF button, unplug the power cord, and allow approximately 5 minutes
for the motor to cool down. Plug the power cord back into the outlet and
continue blending.
ASSEMBLY

RESETTING THERMAL PROTECTION