VESTEL VHI90AX Mode D'emploi page 50

8. Attach the inner chimney to the hanging board with four 4 x 8mm screws.
9. Attach the outer chimney to the angle irons with the hook.
Inside chimney
Outside chimney
10. Attach the cooker hood to the angle irons with 16 4mm x 10mm screws.
11. I f you are using the expansion pipe, attach the expansion pipe with the cable tie to
the outlet of the cooker hood. NOTICE :
• The expansion pipe is not needed when you use the active carbon filter.
• Keep expansion pipes short and straight.
• Do not reduce the size of the expansion pipe.
• W hen using an expansion pipe, always install the pipe pulled out to minimize
pressure loss.
• Failure to observe these instructions will reduce the performance and
increases noise levels of the cooker hood.
50 | VESTEL VHI90AX