Replacing The Flaps - Petsafe PPA19-15794 Guide D'installation

Replacing the Flaps

FIG. 13 FIG. 14
FIG. 16 FIG. 17
1. Remove screws from the interior frame of the pet door (Fig. 13).
2. Remove bar and vinyl flap (Fig. 14).
3. If replacing the insulated flap, remove flap clamp with attached insulated
flap (Fig. 15). Remove screws, insulated flap and backing plate from back
of flap clamp. Insert new insulated flap between flap clamp back and
backing plate. Replace and tighten screws (Fig. 16).
4. Insert new vinyl flap and position horizontally and vertically to fit into door
frame. Replace existing bar and tighten screws in place (Fig. 17).
Replacement flaps are available online at www.petsafe.net or by
contacting our Customer Care Centre. For a listing of Customer Care Centre
telephone numbers, visit our website at www.petsafe.net.
8
Cleaning the pet door
Your pet door is constructed in the highest quality material with a toughened
flap and has been designed to last for many years. To maintain its
appearance, occasional wiping with a damp cloth is all that is necessary.
Terms of Use and Limitation of
Liability
1. Terms of Use
FIG. 15
2. Proper Use
3. No Unlawful or Prohibited Use
4. Limitation of Liability
www.petsafe.net
Use of this Product is subject to your acceptance without modification of
the terms, conditions and notices contained herein. Use of this Product
implies acceptance of all such terms, conditions and notices. If you do
not wish to accept these terms, conditions, and notices, please return the
Product, unused, in its original packaging and at your own cost and risk to
the relevant Customer Care Centre together with proof of purchase for a
full refund.
If you are unsure whether this Product is appropriate for your pet, please
consult your veterinarian or certified trainer prior to use. Proper use
includes, without limitation, reviewing the entire Operating Guide and any
specific safety information statements.
This Product is designed for use with pets only. Using this Product in a way
that is not intended could result in violation of Federal, State or local laws.
In no event shall Radio Systems Corporation or any of its associated
companies be liable for (i) any indirect, punitive, incidental, special or
consequential damage and/or (ii) any loss or damages whatsoever
arising out of or connected with the misuse of this Product. The Purchaser
assumes all risks and liability from the use of this Product to the fullest
extent permissible by law.