Measurement And Marking - Petsafe PPA19-15794 Guide D'installation

Before installing your pet door
please read the following step-by-
step instructions carefully.
Tools required
• Hammer
• Jigsaw or Keyhole Saw*
• Drill
• 13 mm (½") Drill Bit
• Wire Cutters
• Slotted & Phillips Screwdrivers
• Tape Measure
• Masking or Painter's Tape
• Pencil
• Scissors
• Safety Equipment
• Duct Tape (Optional)
• Silicone Adhesive (Optional)
• Sandpaper (Optional)

Measurement and marking

Measure the belly height of your pet (Fig. 1). Mark this measurement on
the outside of your door or wall and draw a straight horizontal line (Fig. 2).
Please bear in mind that this line will eventually be the bottom of the hole
you will cut in your door or wall and that the frame of the pet door will be
slightly lower.
FIG. 1
(X)
4
*use appropriate blade type and
length. Example: A metal door
would require a blade for metal.
FIG. 2
(X)
www.petsafe.net
Cutting a hole for your pet door
The hole that you cut will depend on the thickness of the surface you are
installing the pet door in and the size of pet door you have purchased
(Chart 1). Please note that additional tools, materials and competent DIY
skills may be required.
CHART 1
Cut-out Size Guide
Wall/Door
Pet Door
< 54 mm thick
Model
(Use Cutting Template - A)
Small 258 mm H x 165 mm W
Medium
360 mm H x 241 mm W
Large 489 mm H x 292 mm W
FIG. 3
FOR SAFETY REASONS IT IS NOT RECOMMENDED
TO FIT THIS PRODUCT TO GLASS.
Using the correct template according to Chart 1, position the
template base at belly height marked on door (X). Drill holes at
appropriate corners as indicated (Fig. 3).
(X)
NOTICE: When applying cutting template there should be a
minimum of 8 cm between the bottom and sides of your door
and the outer edge of the cutting template to maintain the
structural integrity of the door.
FIG. 4 FIG. 5
Holding the jig or key-hole saw level, cut along
the appropriate cutting line (Fig. 4). Smooth out
any rough edges with sandpaper (Fig. 5).
(X)
Wall/Door
≥ 54 mm thick
(Use Cutting Template - B)
258 mm H x 142 mm W
360 mm H x 216 mm W
464 mm H x 269 mm W