Important Safety Information - Petsafe PPA19-15794 Guide D'installation

Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd.,
Radio Systems Australia Pty Ltd. and any other affiliate or Brand of Radio
Systems Corporation may be referred to collectively as "We" or "Us".

IMPORTANT SAFETY INFORMATION

Explanation of Attention Words and Symbols used in this guide
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
WARNING indicates a hazardous situation which, if
not avoided, could result in death or serious injury.
CAUTION, used with the safety alert symbol,
indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTICE is used to address practices not related to
personal injury.
• When children are present in the home, it is important to
consider the pet door during child proofing activities, the
pet door may be misused by a child resulting in the child accessing potential
hazards that may be on the other side of the pet door. Purchasers/
Homeowners with swimming pools should ensure that the pet door is
monitored at all times and that the swimming pool has adequate barriers to
entry. If a new hazard is created inside or outside of your home, which may be
accessed through the pet door, Radio Systems Corporation recommends that
you properly guard access to the hazard or remove the pet door. The closing
panel or lock, if applicable, is provided for aesthetic and energy efficiency
purposes and is not intended as a security device. Radio Systems Corporation
will not be liable for unintended use and the purchaser of this product accepts
full responsibility for oversight of the opening it creates.
• Power Tools. Risk of severe injury; follow all safety instructions for power tools.
Be sure to always wear safety goggles and other proper safety equipment.
• For safety reasons it is not recommended to fit this product to glass.
2
door and determine, along with a licensed contractor, its suitability in a given
installation. This pet door is not a fire door. It is important for the owner and
contractor to consider any risks that may be present inside or outside of the pet
door, and any risks that may be created by subsequent changes to your
property and how they may relate to the existence and use, including misuse of
the pet door.
• Be sure to use heavy scissors for cutting the tunnel extensions.
• If cutting a metal surface, be aware of sharp edges to prevent injury.
• Keep these instructions with important papers; be sure to transfer
these instructions to the new owner of the property.
• If painting the pet door, it is recommended to paint it prior to installation. For
best results, use a primer for plastics before applying paint.
• If homeowner's door or other application is not level, the pet door must be
marked level to swing properly.
• When applying cutting template there should be a minimum of 8 cm between
the bottom and sides of the door and the outer edge of the template to
maintain the structural integrity of the door.
• Make sure there is nothing behind the door where you will be drilling the holes
or cutting out opening.
• Use a manual screwdriver to tighten screws. Do not overtighten.
Overtightening can strip the screws or warp the pet door frame.
• Unauthorised changes or modifications may void the user's authority to
operate this equipment and void the warranty.
SAVE THESE INSTRUCTIONS
www.petsafe.net
• The user, prior to installation, must become familiar with
all building codes that may affect the installation of the pet