Fitting The Blind; Using The Blind - Dometic Softrollo Instructions De Montage Et De Service

Softrollo
3

Fitting the blind

Fixing the blind (fig. 2, page 2)
A
NOTICE!
• If the screws supplied do not hold in the wall, you must use plugs
suitable for the wall construction.
• Make sure you do not drill through the wall.
➤ Align the blind with the window cut-out and fasten the blind to the wall with the
screws. Pre-drill if the wall construction requires this.
Fitting the guide rails (fig. 3, page 3 to fig. 4, page 3)
➤ Choose suitable ends for the guide rails.
– Cover for fixing under the guide rail (fig. 1 3, page 2)
– Adapter for fixing next to the guide rail (fig. 1 4, page 2)
➤ Fasten the guide rails to the wall with the screws, at right-angles to the cassette.
Pre-drill if the wall construction requires this.
4

Using the blind

Closing the blind
➤ Pull the bottom rod of the blackout system down and push it to the required
position.
➤ Pull the top rod of the flyscreen down and push it to the required position.
Opening the blind
➤ Push the rods back up.
EN
Fitting the blind
5