Starting And Stopping - Husqvarna 120i Manuel D'utilisation

Starting and stopping

WARNING! Note the following before
!
starting:
Never start a chain saw unless the bar,
chain and all covers are fitted correctly.
Otherwise the drive sprocket can come
loose and cause personal injuries.
Make sure you have a secure footing and
that the chain cannot touch anything.
Keep people and animals well away from
the working area.
• Before inserting the battery into the machine, always
check to see that the power trigger actuates properly
and returnes to the "OFF" position when released. To
prevent the power trigger from being accidentally
pulled, a power trigger lockout is provided. (Figure
54)
• Never start a chain saw unless the bar, chain and all
covers are fitted correctly. See instructions under the
heading Assembly. (Figure 55)
• Observe your surroundings and make sure that there
is no risk of people or animals coming into contact
with the cutting equipment. (Figure 56)
• Always hold the saw with both hands. The right hand
should be on the rear handle, and the left hand on the
front handle. All people, whether right or left handed,
should use this grip. Use a firm grip with thumbs and
fingers encircling the chain saw handles. (Figure 57)
Starting
• Insert the battery in the machine. The battery should
slide easily into the battery holder on the machine. If
the battery does not slide in easily, it is not being
inserted correctly. (Figure 58)
• Press down on the battery. You will hear a click as the
battery locks itself into place. (Figure 59)
• Press and hold the start button (>1 sec.) until the
green LED is lit. (Figure 60)
Stopping
The machine is deactivated by pressing the start/stopp
button on the keypad (green LED off). (Figure 60)
Note! To avoid involuntary start up, the battery must
always be removed when the machine is not in use or is
unsupervised. To remove the battery, withdraw it from the
machine while pressing the battery release buttons on the
battery. (Figure 61)
22 – English
STARTING AND STOPPING