Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Before you Begin
Tools and Parts Needed
Parts Included
27" Appliances
General Information
Power Requirements
Dimensions for 27" Wall-Mounted Units
•
Phillips head screwdriver
•
Measuring tape
•
Drill with bit (1/8")
•
Phillips head screws (6)
The outlet must be properly grounded in accordance with all applicable codes.
Single Oven 27"
It is good practice, when oven is in-
stalled at the end of a cabinet run, ad-
jacent to a perpendicular wall or
cabinet door, to allow at least 1/4"
space between the side of the oven
and the wall/door.
For oven support, install 2x4's extend-
ing front to back flush with the bottom
and the side of the opening. The sup-
porting base must be well secured to
the floor/cabinet and level.
Note: The conduit box must be in-
stalled either above or below the unit. If
the conduit box is installed below the
unit, a 2" diameter hole or space is re-
quired between the back wall and the
right rear of the 2x4 supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 210 lbs (95 kg).
5
Publicité
Table des Matières
