EINHELL OPAL Instructions De Montage page 4

2/f: Then place the base plate on the connectors in
the floor profile and retighten the nuts. In addition,
fasten the base plate to the base with two hex
screws and nuts as well (see inside view). Attach the
mounting bracket which was removed in step 2/e with
another two hex screws and nuts on the two lower
holes on the base. Finally, tighten the last four nuts
from the outside.
Page 13
Important note (Fig. 2/g):
Position the connectors on the front and rear wall as
shown in the relevant reference diagrams on the
following pages. Do not fasten these connectors to
the base as well.
!
Important note:
Once you have finished assembling the greenhouse, check all nuts, bolts and
screws to ensure that they are all securely tightened. Tighten any that are loose.
4
ABA_OSR_FU_Titel+GB.pmd 4
Page 14
Top illustration: Reference diagram (inside)
of the front wall with single door
Bottom illustration: Reference diagram (inside)
of the front wall with double door
Page 15
Bottom illustration: Reference diagram (internal
view) of the rear wall
07.04.2006, 13:01