Operation; Important - Beyerdynamic DT 100 Notice D'utilisation

Operation

The DT 100/102 studio headphone and the DT 108/109 headset
are professional products. It is important that the external
equipment they are connected to is of similar quality and has the
correct impedance and power ratings to achieve the best
performance. Please refer to the "Technical Specifications" for
detailed information.
Convention states that when using the DT 108/109 the boom
microphone is placed over the left ear. The microphone can be
used from the right ear, but if true L and R headphone status
needs to be maintained, it will be necessary to make a custom
lead with the headphone connections reversed (swap brown/
orange on the left side and red/blue on the right side). For
connections refer please to "Block Diagram".
Tighten flat screw and put cap on turning knob.
4
The microphone should be positioned to the side of the mouth,
about 20 - 30 mm forward. This will keep it within the direct
sound path, but out of the breath stream, therefore minimising
any 'pop' sounds.

Important!

Please note that there have been two versions of ear cup
connecting cables used during production. The older DT 100
models have a cable with screw terminal contacts whereas later
versions have soldered connections. Please make sure the correct
cable version is requested when ordering.
Lift cap with small
1
screwdriver.
Loosen flat screw.
2
Turn disc 180°. Nose of the
3
disc points to the upper
end. of the boom arm.
11