Noise/Vibration Information; Declaration Of Conformity - Bosch GSR 9,6-2 PROFESSIONAL Instructions D'emploi

2 609 140 319.book Seite 5 Mittwoch, 1. März 2006 9:25 09

Noise/Vibration Information

Measured values determined according to
EN 60 745.
Typically the A-weighted sound pressure level of
the machine is 80 dB (A). Measurement uncer-
tainty K=3 dB.
When working, the noise level can exceed
85 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
The vibration emission level
WARNING
given in this information sheet
has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used
to compare one tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to a significant un-
derestimate of exposure when the tool is used
regularly in such a way.
NOTE: To be accurate, an estimation of the level
of exposure to vibration experienced during a
given period of work should also take into ac-
count the times when the tool is switched off and
when it is running but not actually doing the job.
This may significantly reduce the exposure level
over the total working period.
13 • 2 609 140 319 • 06.03
Service and
Customer Assistance
Exploded views and information on spare
parts can be found under:
www.bosch-pt.com
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
2
.
North Orbital Road
Denham-Uxbridge
Middlesex UB 9 5HJ
Service
............................
Advice line
....................
Fax
.............................................
Ireland
Beaver Distribution Ltd.
Greenhills Road
Tallaght-Dublin 24
Service
...................................
Fax
....................................................
Australia and New Zealand
Robert Bosch Australia Pty. Ltd.
RBAU/SPT
1555 Centre Road
P.O. Box 66
3168 Clayton/Victoria
.............................................
Fax
.............................................
www.bosch.com.au

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following stand-
ards or standardization documents: EN 60 745
according to the provisions of the directives
89/336/EEC, 98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
Subject to change without notice
English - 5
+44 (0) 18 95 / 83 87 82
+44 (0) 18 95 / 83 87 91
+44 (0) 18 95 / 83 87 89
+353 (0)1 / 414 9400
+353 (0)1 / 459 8030
+61 (0)1 / 3 00 30 70 44
+61 (0)1 / 3 00 30 70 45
Dr. Eckerhard Strötgen
Head of Product
Certification