Product Specifications - Hitachi C 10RB Mode D'emploi Et Instructions De Securite

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals (known to the State of California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such
as dust masks that are specially designed to filter out microscopic particles.
MOTOR
HP (Maximum developed) ......................... 4.4
Type .......................................................... Universal
Amps ......................................................... 15
Voltage ...................................................... 120
Hz .............................................................. 60
RPM (no load) ........................................... 4000
Overload Protection ................................... YES
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt /
15 Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is
worn, cut or damaged in any way.
Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow
these rules could result in serious injury to you or damage to the table saw.
All manuals and user guides at all-guides.com
PRODUCT SPECIFICATIONS
WARNING
SAW
Table Size with Extensions .......... 30-3/32" x 21-3/4"
Table Extension ........................... Right
Rip Capacity with Extension ......... 24-1/2"
Blade Size .................................... 10"
Rip Scale ...................................... YES
Rip Fence ..................................... YES
Miter Gauge ................................. YES
Maximum Cut Depth @ 90º .......... 3-1/8"
Maximum Cut Depth @ 45º .......... 2-1/4"
Maximum Dado Cut Width ........... 13/16"
Net Weight ................................... 70.4 LBS
WARNING
– 3 –
English