Installation; Electrical Connection; Wheel Mounting - Zipper Zi-Rwm99 Mode D'emploi

16

INSTALLATION

The machine must be installed on level ground and there is no need to anchor the machine to the
floor for correct operation

ELECTRICAL CONNECTION:

Electrical connection must be done by specialized people
Before connecting the balancer to the power supply, check the voltage that showing on the nameplate
at the back of machine.
The machine mains supply cable should be fitted with a plug conforming to current regulations.
It is advisable to provide the machine with its own electrical connection through a suitable circuit
breaker.
When connection is made directly to the mains control panel, without using any plug, it is advisable to
padlock the main switch of the balancing machine so that its use is limited only to authorized person-
nel.

WHEEL MOUNTING

The machine is supplied as standard with a universal cone adapter. The adapter body build-in spring
cannot be disassembled from the spindle. The threaded end is removable in order to allow mounting
alternative adapters.
PRESETTING OF DIMENSIONS
Press distance "a" on the inside of the wheel from the machine measuring with the
Abb. 3
special gauge. Increment pitch 0.5 cm Full scale 25cm.
Preset the nominal width which is generally given on the rim, or else measuring width
"b" with the caliper gauge.
Increment pitches:
-unit of measurement mm: 5mm
-unit of measurement inch: 0.25''
the following is displayed:
.5 for 1/2''
.7 for 3/4''
Preset the nominal diameter "d" stamped on the type:
Increment pitches:
-unit of measurement mm: 12/13mm
-unit of measurement inch: 0.5''
Abb. 2
.2 for 1/4''
22