Connecting The Monitor To A Computer (Pc Etc.) - Sharp LL-T2010W Mode D'emploi

Connecting the monitor and turning the monitor on and off
Connecting the monitor to a computer
(PC etc.)
Connect using this device's analog signal
cable
Connect this device's analog signal cable to the
computer (PC etc.).
When connecting, ensure that both the monitor and
computer are switched off.
Be careful not to overly bend the cable or add
extension cords as this could lead to malfunction.
Firmly insert the analog RGB output
terminal (mini D-sub 15 pin with 3 rows)
then tighten the screws each side.
Analog signal cable
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal cable.
Macintosh conversion adapter
Analog signal cable
After connecting the adapter, tighten the
screws on each side to fix into place.
Note:
- If connecting to the Sun Ultra series, a
conversion adapter (commercially available) may
be required.
Connect using a display cable (to be pur-
chased separately)
- Using a display cable (to be purchased
separately), it can be connected to the
computer's (PC etc.) digital RGB output terminal
or analog RGB output terminal.
- To connect to a digital RGB output terminal:
Digital signal cable (model name: NL-C01E)
- To connect to an analog RGB output terminal:
Analog signal cable (model name: NL-C02E)
- For a digital signal input: It can be connected to a
computer with a DVI-compatible output terminal
(DVI-D24 pin or DVI-I29 pin) and which has
UXGA output ability. Depending on the computer
to be connected, correct display may or may not
be possible.
- Be careful not to overly bend the cable or add
extension cords as this could lead to malfunction.
1.Remove the cover.
(Rear View)
2.Connect the display cable (to be purchased
separately) into the DVI-I input terminal.
3. Replace the cover.
13
Cover
DVI-I input terminal
Display cable
(to be purchased
separately)
To the computer's
RGB output
terminal